Sprinkler head watering a green Houston lawn at sunset

Houston, Texas

Houston sprinkler repair done right the first time

Broken heads, dead zones, stuck valves, hidden leaks, and controllers that won't hold a program — we diagnose the actual fault and fix it, across the entire Houston metro.

Licensed Texas Irrigators

Every repair performed to state irrigation code by licensed technicians.

Same-Week Scheduling

Most repairs are diagnosed and completed in a single visit.

Houston Metro Coverage

Crews across Harris, Fort Bend, Montgomery, Brazoria, and Galveston counties.

All Major Brands

Rain Bird, Hunter, Toro, Irritrol, Weathermatic, K-Rain, and more.

Technician repairing an irrigation valve manifold

Why homeowners call us

We diagnose before we dig

Houston's gumbo clay, hard water, and heat cycles are hard on irrigation. Most systems we see have three or four small problems compounding into one big symptom. We test every zone, check controller output, trace field wiring, and confirm the fault before a shovel comes off the truck.

  • Zone-by-zone run test on every visit
  • Wire tracing to locate buried valve boxes
  • Parts matched to your existing heads and nozzles
  • Arcs, radius, and schedule corrected before we leave
More about our team

Common questions

How do I know if my sprinkler system has a leak?

The most common signs are a spike in your water bill, a section of lawn that stays soggy between cycles, and a drop in pressure across multiple zones. If the meter's low-flow indicator moves while every zone is off, water is escaping somewhere in the system.

Why is one zone not turning on?

Nine times out of ten it is a solenoid valve, a broken field wire, or a bad controller output. A technician can isolate which of the three it is in a few minutes by testing resistance at the controller terminal.

How often should a sprinkler system be inspected?

Twice a year is ideal for the Houston area: once at spring startup and once before the first hard freeze. An annual audit at minimum will catch buried heads, misaligned arcs, and slow leaks.

Is backflow testing required in Texas?

Yes. Irrigation systems connected to a public water supply must have their backflow prevention assembly tested annually by a licensed tester, and the results filed with the local water authority.

How long should each zone run?

It depends on head type, soil, and sun exposure. Rotor zones on clay typically need longer cycles split into two shorter runs so water can soak in, while spray zones on beds usually need much less. We set this during a tune-up.

Can you find a valve if I don't know where it is?

Yes. We use a wire tracer to follow the field wiring from the controller to the valve, which locates buried boxes without trenching across the yard.

See all FAQs

What Houston homeowners say

4.9 average from 12 customer reviews
“Two zones had quit on us and another company told us the whole manifold had to be replaced. The tech from Reliable traced it to a bad solenoid and a nicked wire, fixed both, and ran every zone with me before he left. Straight answers the whole way through.”
Marcus D. Katy, TX · Valve Repair & Replacement · June 9, 2026
“Our water bill nearly doubled and we could not find the cause. They located a cracked lateral under the side yard in about forty minutes, repaired it, and put the sod back so neatly you cannot tell where they dug.”
Priya S. Sugar Land, TX · Leak Detection & Repair · May 28, 2026
“Eleven heads replaced and every arc reset. The shade zones under the oaks were drowning and the sunny strip was burning up — they rebalanced the whole thing and the lawn evened out within two weeks.”
Bill R. The Woodlands, TX · Sprinkler Head Replacement · May 14, 2026

Sprinkler trouble? Call us now.

Talk to a Houston-based technician about what your system is doing — we diagnose before we dig.